TE0706 Quick Start

[rawl_dog]

Forgive me... I'm a long-time Xilinx ISE guy, but new to Vivado.

I've purchased the following:
TE0715-04-15-1I3
TE0706-02
TE0790-02

I'm trying to perform some sanity checks by performing the following:

• Assemble PCA stack
• Set TE0706 VCCIO jumpers
  VCCIOA - M3.3VOUT
  VCCIOB - M3.3VOUT
  VCCIOC - M3.3VOUT
• Set TE0706 switches
  S1.1 - don't care
  S1.2 - PROGMODE - ON - JTAG enabled
  S1.3 - MODE - OFF - QSPI Boot
  S1.4 - EN1 - OFF - power enabled
• Set TE0790 switches
  S1.1 - normal mode - ON
  S1.2 - reserved - OFF
  S1.3 - VIO power source - OFF - J2
  S1.4 - 3.3 power source - OFF - J2
• Power PCA stack with 5V
  Draws 650mA
• Test my target JTAG connection
  Computer connected to TE0790 via USB cable
• Download prebuilt TE0715 Test Board project
  https://wiki.trenz-electronic.de/display/PD/TE0715+Test+Board
• Build and download my own simple project
  https://www.xilinx.com/support/documentation/sw_manuals/xilinx2017_3/ug940-vivado-tutorial-embedded-design.pdf

Unfortunately, I'm stuck at step 6 as I have no idea how to use Vivado to connect to the TE0790 adapter...

Thanks in advance,

Brad

[JH]

Hi,
TE0790(XMOD) DIP for TE0706 (VIO from Board, 3.3V from USB): 1ON,2OFF,3OFF,4ON --> see https://wiki.trenz-electronic.de/display/PD/TE0790+TRM#TE0790TRM-DIP-switch

JTAG on Vivado:

   
• Install Vivado
• Connect JTAG from XMOD to PC
• Power on your setup
• Create Reference Design like described here:
• https://wiki.trenz-electronic.de/display/PD/TE0715+Test+Board#TE0715TestBoard-Hardware
• --> te0715-03-15-1i3 is the same as te0715-03-15-1i
• https://wiki.trenz-electronic.de/display/PD/TE0715+Test+Board#TE0715TestBoard-DesignFlow
• -->a make step 1 to 4
• Open Vivado HW Manager (PS: It's also possible to open Vivado HW Manager without Design Generation and connect)
• Run Auto Connect
• You should see ARM +FPGA Part (PS: if you download Bitfile only, PS (ARM) is not initialise)

Links for programming and debugging:

   
• https://wiki.trenz-electronic.de/pages/viewpage.action?pageId=14746264#Vivado/SDK/SDSoC-XilinxSoftwareProgrammingandDebugging

PS: First step use SD Boot and try prebuilt files with instructions from here:

   
• https://wiki.trenz-electronic.de/display/PD/TE0715+Test+Board#TE0715TestBoard-Launch

br
John

[rawl_dog]

Thanks, John!

As you noticed, it was simply the JTAG power source switch...

Cheers,

Brad