Author Topic: TEBF0808 board power on after power cycle  (Read 7067 times)

marvind

  • Active Member
  • *
  • Posts: 4
TEBF0808 board power on after power cycle
« on: January 13, 2017, 03:41:00 PM »
Hello,

in the default configuration the power button needs to be pressed after power cycling the PSU to power on the board. is it possible to configure the TEBF0808 to be powered on immediately after power cycling?
On a related note, I was unable to find documentation about the configuration jumpers (S4). Could you please point me to/add this information in the wiki?

Kind regards
Marvin

Antti Lukats

  • Hero Member
  • *****
  • Posts: 542
Re: TEBF0808 board power on after power cycle
« Reply #1 on: January 16, 2017, 09:12:14 AM »
The power up behaviour can be changed as needed, it is made loosely PC like, so it does not auto power-up a the moment.

marvind

  • Active Member
  • *
  • Posts: 4
Re: TEBF0808 board power on after power cycle
« Reply #2 on: January 16, 2017, 11:40:31 AM »
How can I change the power up behaviour?

Thanks
Marvin

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1987
Re: TEBF0808 board power on after power cycle
« Reply #3 on: February 09, 2017, 08:02:10 AM »
Hi,

power management is included in the two CPLDs of the TEBF0808. Currently implementation is described here:

Write source code request to Trenz Electronic support, if it's important for you to change the power management.
 
br
John