Boot image compatibility between AMB0010-01 and TEB0955-02 base boards

[blee]

Hi.
I built a image file for AMB0010 Base with TE0955-01 SOM using TE0955-te0955-rd-vivado_2024.2-build_1_20250707150046.zip

Can I use that image file for TEB0955-02 Base with TE0955-01 SOM directly ?

Thanks a lot

[Antti Lukats]

Can I use that image file for TEB0955-02 Base with TE0955-01 SOM directly ?

should work, yes.

[blee]

Hi,
Thank you for your previous response confirming that the boot image built for the AMB0010 base board should work on the TEB0955-02 base board with the TE0955-01 SOM.

However, I am still facing a boot failure when using the exact same image on the TEB0955-02 setup.

To provide more details on the boot issue with the TEB0955-02 base board, I have tested different module combinations and found the following results:

AMB0010-01 Base Board: Both TE0955-01 and TE0955-02 SOMs boot up successfully with the image.
TEB0955-02 Base Board: Neither TE0955-01 nor TE0955-02 SOM boots up using the exact same image and setup.

Could you please provide further guidance or troubleshooting steps for this? Specifically, are there any differences in the hardware configuration (such as boot mode switch settings, or clock configurations) between the AMB0010 and TEB0955-02 that I might need to adjust for the TEB0955-02 board?

Thanks a lot

[MA]

Hi,

which configuration did you use?

For SD boot mode, please configure the TEB0955 as follows:

• S3.1:ON
• S3.2:OFF
• S3.3:ON
• S3.4:OFF

Then please try again.

Regarding the power supply, please use a 12 V / 2 A power supply if possible.

br

[blee]

Hi.
Thank you for the prompt guidance.
I have configured the TEB0955 base board for SD boot mode as you instructed:
S3.1: ON
S3.2: OFF
S3.3: ON
S3.4: OFF
And I am using a 12V power supply also as recommended.
thanks

[MA]

Hi,

and now its working or not?

br

[blee]

Hi.
The board still does not boot.
(Boot switch=1(on), 2(off), 3(on), 4(off) and 12V power supply are used)

When I power on the TEB0955-02 baseboard, the LEDs on the TE0955-02 SOM turn on briefly and then turn off immediately)
And nothing is displayed on Tera Term.

As a side note, regarding the AMB0010-01 baseboard, there are two TE0790-03 units, and I connected Tera Term to the TE0790-03 unit wired to UART-1.
Could this be related to the current boot failure on the TEB0955?

Or Could you please provide further guidance or troubleshooting steps for this.
Thanks.