Boot image compatibility between AMB0010-01 and TEB0955-02 base boards

[blee]

Hi.
I built a image file for AMB0010 Base with TE0955-01 SOM using TE0955-te0955-rd-vivado_2024.2-build_1_20250707150046.zip

Can I use that image file for TEB0955-02 Base with TE0955-01 SOM directly ?

Thanks a lot

[Antti Lukats]

Can I use that image file for TEB0955-02 Base with TE0955-01 SOM directly ?

should work, yes.

[blee]

Hi,
Thank you for your previous response confirming that the boot image built for the AMB0010 base board should work on the TEB0955-02 base board with the TE0955-01 SOM.

However, I am still facing a boot failure when using the exact same image on the TEB0955-02 setup.

To provide more details on the boot issue with the TEB0955-02 base board, I have tested different module combinations and found the following results:

AMB0010-01 Base Board: Both TE0955-01 and TE0955-02 SOMs boot up successfully with the image.
TEB0955-02 Base Board: Neither TE0955-01 nor TE0955-02 SOM boots up using the exact same image and setup.

Could you please provide further guidance or troubleshooting steps for this? Specifically, are there any differences in the hardware configuration (such as boot mode switch settings, or clock configurations) between the AMB0010 and TEB0955-02 that I might need to adjust for the TEB0955-02 board?

Thanks a lot

[MA]

Hi,

which configuration did you use?

For SD boot mode, please configure the TEB0955 as follows:

• S3.1:ON
• S3.2:OFF
• S3.3:ON
• S3.4:OFF

Then please try again.

Regarding the power supply, please use a 12 V / 2 A power supply if possible.

br