TEBF0818 CPLD Access not working

[ffloresg]

Hello,

I am working with TE0808 on dev board TEBF0818.

I am trying to access and program the Lattice CPLDs on the TEBF0818 development board. I followed steps 1 to 6 in the CPLD Access section of the following guide: https://wiki.trenz-electronic.de/display/PD/TEBF0818+CPLD+Firmware

However, the Diamond Programmer did not found any device and created a default blank project.

Do you have any idea what might be causing this issue or how it could be resolved?

Thanks in advance.

Best regards,
Fernando

[MA]

Hello Fernando,

please ensure that the DIP switch S4.3 is set to "ON"; if it is set to "OFF", this is exactly the behaviour you are experiencing.

• https://wiki.trenz-electronic.de/display/PD/TEBF0818+Getting+Started#TEBF0818GettingStarted-Overview
• Number 7

Best regards,

Manuela

[Antti Lukats]

in your screenshot the Lattice programmer did show: FTUSB1 it should however be FTUSB0 !