QSPI Programming Issue

[mucahityldrm10]

Hi everyone,

I'm usin te0720-04-62I33ML 4x5 SoM. Also I have te0705 simpllified cariier board. I'm using vivado 2022.1
I wrote a simple standalone LED blink code, and I can debug it normally, and it works. However, when I compile and try to load this code with FSBL for the QSP flash, Vivado gives the following error. It says I can't get the processor into JTAG boot mode. No matter what I do, I can't get the system into JTAG boot mode. It's either in SD card mode or QSP mode. The configuration you've made on the carrier board is as shown in the image below. I need urgent help. Thank you for your support.

[MA]

Hi,

it looks as your CPLD Firmware is not prepaired for JTAG Boot Mode. Can you please update your firmware and try again?

• https://www.trenz-electronic.de/Downloads/?path=Trenz_Electronic/Modules_and_Module_Carriers/4x5/TE0720/REV04/Firmware
• https://wiki.trenz-electronic.de/display/PD/TE0720+CPLD+Firmware

Another option would be to use an older Vivado version (prior to 2021) to programme the QSPI.

br, Manuela