Flash memory on TE0710 from Microblaze being programmed

[gapbesides]

I attempted to use QSPI to write to the module's flash memory, but I'm having trouble getting the right data to be stored there. The written data has incorrect bytes at the beginning.
I made every effort to see if the page alignment of the memory was the cause of the issue, but I was unable to resolve it even by moving the address I obtained from figuring out the start address of a page. Does anyone have any past writing experience with this device?

[JH]

Hi,
we have a reference design with QSPI online, where QSPI is included, also into petalinux example:
https://wiki.trenz-electronic.de/display/PD/TE0710+Test+Board
br
John