TEL0001 Documentation

[Len]

I purchased two of these modules also known as LXO2000. I looked for some documentation and found a wiki page that when documentation was selected the wiki page was displayed again. Where can I find the documentation? It says it is Ardunio compatible, so there must be a link to where the Ardunio software for the board is so Ardunio can download and integrate the software with it. Where is that? I will most likely use the Lattice software to program the device, but I would like to be familiar with all its capabilities. I see some LEDs and a couple of switches and a lot of unlabeld pins. There must be a schematic, where can I download it?

[mch]

Hi,

You can find in the following link the schematic of the board:

https://shop.trenz-electronic.de/de/TEL0001-02-LXO2000-mit-Lattice-XO2-4000-On-Board-USB/JTAG-2-5-x-6-15-cm?path=Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEL0001/REV02/Documents

https://shop.trenz-electronic.de/trenzdownloads/Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEL0001/REV02/Documents/SCH-TEL0001-02.PDF

with kind regards
Mohsen

[Len]

Thanks for the schematic. Is there a Users Guide in English? I noticed two com ports when I plugged it into a USB and would like to get past admiring the fine workmanship of the board.

[mch]

Hi,
 
unfortunately there is no manual for this board yet. But you can use the schematic that I sent yesterday for you.

With kind regards
Mohsen