Author Topic: Initiate AXI DMA transfer with Custom Axi Lite Master IP block  (Read 1346 times)

trek123

  • Guest
Initiate AXI DMA transfer with Custom Axi Lite Master IP block
« on: February 25, 2020, 08:32:06 AM »
Hello everyone, I want to send data from PL to PS and PS to PL by using AXI DMA IP block in Embedded Linux. In order to do that, I want to write AXI DMA address space with FSM by using AXI Custom Block to initate the transfer own my own. Here is my strategy;

- 1) Writing 0x0001 to control register(4040_0000) of DMA block

- 2) Writing 0xe000 to MM2S_START_ADDRESS register (4040_0018) of DMA block

- 3)  Lastly Writing 0x0020 to MM2S_LENGTH register (4040_0028) of DMA block

However, I cannot write data to these addresses, although I can write the other addresses(for example 0x0600_0000). My fsm in the AXI Custom Block is in the attached file.

Thank you for your any help...

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1997
Re: Initiate AXI DMA transfer with Custom Axi Lite Master IP block
« Reply #1 on: February 25, 2020, 10:38:57 AM »
Hi,

did you check address mapping of your IP in the vivado design?
You use the correct offset to get access to your IP?  --> you can autoasign offset or give manually, possible address range is different on Zynq and ZynqMP and also depends on the AXI PS interface.
See:
https://www.xilinx.com/support/documentation/user_guides/ug585-Zynq-7000-TRM.pdf
https://www.xilinx.com/support/documentation/user_guides/ug1085-zynq-ultrascale-trm.pdf

PS: Maybe you should also write to Xilinx forum, it's SoC device internal question, so you get maybe faster an answer/solution.

br
John