Author Topic: PA6H (FGPMMOPA6H) and $PGTOP (Antenna Advisor)  (Read 14939 times)

Hengist

  • Global Moderator
  • Jr. Member
  • *****
  • Posts: 54
PA6H (FGPMMOPA6H) and $PGTOP (Antenna Advisor)
« on: July 17, 2013, 12:44:17 PM »
Q: why do some PA6H (GlobalTop FGPMMOPA6H) modules output $PGTOP,11,x (Antenna Status, Antenna Advisor) sentences and others do not?

The original standard PA6H firmware AXN2.10_5051 outputs $PGTOP,11,x sentences (antenna status/advisor messages) when PA6H is powered on.
However, some customers have been complaining about this behavior.

The current standard PA6H firmware AXN2.10_5263 does not output $PGTOP,11,x sentences (antenna status/advisor messages) when PA6H is powered on. Customer can still enable output of $PGTOP,11,x sentences (antenna status/advisor messages) when PA6H is powered on by sending command packet $PGCMD,33,x to the module.


Code: [Select]
$PGCMD,33,mode*checksum
Mode:
  • 0: disable antenna status indicator messages
  • 1: enable antenna status indicator messages
  • 2: query which mode is currently set;
    • response packet 0: antenna status/advisor messages are disabled
    • response packet 1: antenna status/advisor messages are enabled


Examples of packet command:
Code: [Select]
$PGCMD,33,0*6D<CR><LF> (disable antenna status/advisor messages)

$PGCMD,33,1*6C<CR><LF> (enable antenna status/advisor messages)


Examples of acknowledgment:
Code: [Select]
$PGACK,33,0*6E<CR><LF> (antenna status/advisor messages are disabled)

$PGACK,33,1*6F<CR><LF> (antenna status/advisor messages are enabled)

Customer can also send the $PGTOP,11 command to PA6H module to inquiry the antenna status.
Code: [Select]
$PGTOP,11,3 *6F<CR><LF> (inquiry antenna status)

Response packet:
$PGTOP,11,value*checksum
Value:
 1=>Active Antenna Shorted
 2=>Using Internal Antenna
 3=>Using Active Antenna
« Last Edit: March 19, 2014, 02:17:26 PM by Horsa »