Print Page - TE0720 1.8V DCDC failure

Title: TE0720 1.8V DCDC failure
Post by: q.li on August 15, 2017, 05:18:31 AM

We have two TE0720 boards failed with U3 1.8v DCDC power IC burnt.
Has any one encountered the same problem. Is there any solution to avoid the problem.

Regards,

Title: Re: TE0720 1.8V DCDC failure
Post by: Thorsten Trenz on August 15, 2017, 02:11:57 PM

Hi,
you can sent the shematic of your setup to support at trenz- electronic.de
We will review it, and may point out possible reasons.
In general, there is no problem with 1.8V powersupply.

Best Regards,
Thorsten Trenz

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: q.li on August 15, 2017, 05:18:31 AM