Hello,
We are designing a custom base board/carrier board for the TE0712 module in Eagle. I just wanted to know if Trenz electronics provides any eagle library for the Samtec (LSHM) connectors with proper positioning that we can use directly ?
In fact the webpage for "4x5 Module Integration Guide" : https://wiki.trenz-electronic.de/display/PD/4x5+Module+Integration+Guide , says something like this "It is highly recommended to use the Base board Template designs as a starting point for new PCB designs". However, I couldn't find this base board template design anywhere on the website.
Any help would be greatly appreciated !
Thanks,
SP
Hi,
we do not use Eagle, but we have a customer supplied one for the TE0720. Connector positions are the same:
https://shop.trenz-electronic.de/de/Download/?path=Trenz_Electronic/TE0720/REV02/HW_Design
As this is customer supplied, and we do not use Eagle, we did not check it, and we do not take any liability for any errors.
Best Regards,
Thorsten Trenz
Thanks for the quick reply ! yes, that link contains the eagle library too..I will verify it and use it for my designs..thanks again !
Hi!
I have one custom made from the TE0720 as Thorsten mentioned.
As of yet, I haven't found any errors in it but I don't take any liability of it ::)
I could send it to you if you wan't to use it or just check your own part against it.
Best Regards,
Jonas
Hi,
if you sent it to our support email, we will put it in our download section with comment, that it is customer supplied.
Best Regards,
Thorsten Trenz