Print Page - HDMI with TE0715-xx-30 and TE0701

Title: HDMI with TE0715-xx-30 and TE0701
Post by: fletzerm on November 03, 2016, 04:40:52 PM

Hi,

you provide an HDMI reference design for TE0715-xx-30.
Can be found under https://shop.trenz-electronic.de/de/TE0715-04-15-1I3-SoC-Micromodul-mit-Xilinx-Zynq-XC7Z015-1CLG485I-low-profile?path=Trenz_Electronic/TE0715/Reference_Design/2015.4/hdmi.
But can this design be used with the TE0701 carrier board? Because the voltage for bank 34 have to be set to 1v8.
But this is not possible I think.
Using information from https://wiki.trenz-electronic.de/display/4X5B/TE0701+Jumper+Configurations#TE0701JumperConfigurations-Configuring1.8VSupplyVoltageforTE0715-xx-30 it is only possible to set the voltage to 1v8 for bank 35. But for the HDMI reference design bank 34 is required.

What would be the solution to run the HDMI refernce design with this board combination?

Thanks,
Martin

Title: Re: HDMI with TE0715-xx-30 and TE0701
Post by: Antti Lukats on November 14, 2016, 05:05:06 PM

actually it is, there will be some weak pullups to 2.5V on 1.8V bank, but otherwise all still can work.

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: fletzerm on November 03, 2016, 04:40:52 PM