Print Page - JTAG Debugging on TE7020

Title: JTAG Debugging on TE7020
Post by: Woody242 on June 18, 2015, 05:56:38 PM

Greetins all,

Looking at getting a TE7020 module with the 703 carrier. I currently use the HS3 debugger cable with the Xilinx SDK. It does not appear that the 14 pin connector is available. Is the interface implemented on the carrier card similar to teh digilent modules so I just need the USB cable. If so does anyone know which cable is emulated (HS1, 2, or 3). Before i order i would like to know what debug capabilities to expect and debugging does not seem well covered in the manuals.

Thanks a lot,
Woody

Title: Re: JTAG Debugging on TE7020
Post by: Oleksandr Kiyenko on June 19, 2015, 09:02:17 AM

Hello Woody

TE0703 already have integrated JTAG debug. You just have to connect USB cable to micro-USB connector on board.

Best regards
Oleksandr Kiyenko

Title: Re: JTAG Debugging on TE7020
Post by: Woody242 on June 20, 2015, 04:12:18 AM

Thanks,
Woody

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: Woody242 on June 18, 2015, 05:56:38 PM