Print Page - TE0706-04-A Carrier & TE0820-04-3BE21MA SoM

Title: TE0706-04-A Carrier & TE0820-04-3BE21MA SoM
Post by: Doog on April 16, 2026, 11:09:04 AM

Hi,

I have a TE0706-04-A Carrier board & TE0820-04-3BE21MA SoM.

Are there any board presets / XDC files for this combination.

I am using Viado 2022.2.

Also did I read somewhere that I have to change a resistor on the board.

Thanks in advance for any help.

Title: Re: TE0706-04-A Carrier & TE0820-04-3BE21MA SoM
Post by: Antti Lukats on April 17, 2026, 10:28:06 AM

if you want to use the second PHY then you must make sure R19 is installed, R18 is not needed, can be removed, but most likely is OK when it remains
fitted.

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: Doog on April 16, 2026, 11:09:04 AM