Hello,
I am working with the TE0802-02-1BEV2 module and I would like to use the native Zynq UltraScale+ PS USB controller (USB0 or USB1) in USB Device mode (CDC ACM).
From the TRM I see:
One USB 3.0 Type-A connector listed as USB Host
One Micro-USB connector for JTAG/UART via FTDI
My questions are:
Are the PS USB controllers (USB0/USB1) routed to any physical connector on the TE0802-02-1BEV2 that supports USB Device or OTG mode?
Is it possible to configure the USB 3.0 Type-A port in USB Device mode by software only, or is it hardware limited to Host mode?
If native USB Device is not available on this board, is there any recommended modification or expansion board to expose USB0/USB1 in Device mode?
Thank you in advance for your support.
Best regards,
TE0802 indeed has only Host USB-A connector. Theoretically you should be able to use it as device with custom cable. Cut two cable and solder them so that you have USB-A to USB-A cable (do not connect vbus). This may work.