Hello. I succesfully booted petalinux on one of my soms and then i tried to do it on a couple of other of my devices.
--I formatted the sd to contain 2 partitions (boot/fatfs root/ext4) and flashed image.ub,boot.bin and boot.scr on boot and rootfs.ext4 on root using the dd command.
--i set the dip switches on my carrier board to sd boot mode and plugged in the device.
Got no output on my serial console whatsoever.
I then tried to program the qspi memory and jtag boot, but again i got a "download successful" message but no output. I tried the sd card on my first som and it booted just fine.
Note: I didn't change anything. I tried to flash the image on a second sd card as is. I changed carrier boards to make sure that none of them were faulty. But again only one out of the three of them booted successfuly meaning that i probably haven't done some configurations.
Any advice would be very useful
Hi,
Have you been able to resolve your issue yet? If not, please feel free to send an email to support@trinz-electronic.de.
br, Manuela