Could you please update Assembly Diagrams for TE0701-06 board aka AD-TE0701-06.pdf file with with positions of M2.5 FMC holes, those two near edge of card?
I compared AD-TE0701-06.pdf with AD-TE0701-05.pdf some distances are same, some are off by 0.02mm (which is Ok), but FMC hole near S3 switch is on x-axis off by 1.5mm (maybe mistake), while y-axis distance does not exists.
Also FMC hole near L8 do not have any distances assigned (assume that y-axis distance is same as one of hole near S3).
Considering that even M3 hole changed position between AD-TE0701-06.pdf and AD-TE0701-05.pdf (kind a strange to move them, maybe also mistake, maybe you move them bcs were on the way of power supply), I have pretty low confidence to numbers given in AD-TE0701-05.pdf, so I pledge you to update AD-TE0701-06.pdf.
I have hard time to measure all this, especially 0.2mm tolerance for typical 2.7mm hole M2.5 for FMC.
Similar problem already existed on earlier version of TE0701:
https://forum.trenz-electronic.de/index.php?topic=300.0 (https://forum.trenz-electronic.de/index.php?topic=300.0)
Thanks in advance.
Hi, we updated assembly diagram. Best regards, Maksim Tserabei
Thank you.
I test it and it fit.