Hello,
I bought TE0720-03-1CFA-S Starter Kit. I am planning to connect it to a sensor that has clock and data lanes running at 1.8V.
I tried to set the input buffers in vivado to "LVDS", but vivado reported that HR banks don't support 1.8V.
But when I set it to "LVDS_25" then the implementation runs successfully.
I kept the jumpers on the carrier board as default, all set to 1.8V.
Now my main concern is the following, when I connect the sensor will the Zynq board be able to receive the data coming at 1.8V although the settings are LVDS_25?
Is there any settings that I must pay attention to able to get a successful connection between the sensor and the TE0720 module?
Thank you in advance for your help.
Hasson
Hello Hasson,
HR banks supports only LVDS_25
https://www.xilinx.com/support/documentation/user_guides/ug471_7Series_SelectIO.pdf Page 91
Please check also
https://www.xilinx.com/support/answers/43989.html
Best regards
Oleksandr Kiyenko