Attention: For security reasons,please choose a user name *different* from your login name.
Also make sure to choose a secure password and change it regularly.
QuoteVoltages: When connected to the external supply (no USB connected) I tried to measure between the power supply ground and the 3.3V pin next to pin A (on the getting started schematic) and the boards lights turned off... Which is concerning. Despite all that the board is still detected when powered by the USB and not when powered by external.that's very strange. QSPI was programmed or not programmed before? In case it's not programmed, only done led(Red LED) should be on in case it's not programmed. And this light goes off when you try to measure?
****** Xilinx Program Flash
****** Program Flash v2022.2 (64-bit)
**** SW Build (by xbuild) on 2022-10-13-12:09:39
** Copyright 1986-2022 Xilinx, Inc. All Rights Reserved.
WARNING: Failed to connect to hw_server at TCP:127.0.0.1:3121
Attempting to launch hw_server at TCP:127.0.0.1:3121
Connected to hw_server @ TCP:127.0.0.1:3121
Target not specified. Selecting target_id 2 (arm_dap) by default.
Retrieving Flash info...
Initialization done
Using default mini u-boot image file - C:/Xilinx2022/Vitis/2022.2/data\xicom\cfgmem\uboot\zynq_qspi_x4_single.bin
===== mrd->addr=0xF800025C, data=0x00000001 =====
BOOT_MODE REG = 0x00000001
WARNING: [Xicom 50-100] The current boot mode is QSPI.
Flash programming is not supported with the selected boot mode.If flash programming fails, configure device for JTAG boot mode and try again.
Page created in 0.014 seconds with 13 queries.