News:

Attention: For security reasons,please choose a user name *different* from your login name.
Also make sure to choose a secure password and change it regularly.

Main Menu

J3 on TE0745 carrier

Started by Philipp Bernhardt, July 08, 2021, 11:39:58 AM

Previous topic - Next topic

Philipp Bernhardt

Hi,

is it possible to not place and populate connector J3 on TE0745 carrier board due to BOM cost and space reduction? Will the board boot and run properly without J3 connected?

Best regards
Philipp

JH

Hi,
yes it should be possible. But you didn't have longer access to SD, so QSPI boot only.
See schematics TEB0745 page 4 and TE0745 page 5

From schematics, Bank33, MGT0..3 (and external CLK inputs), some MIO (GPIO, LED Ctrl, Usr Button, I2C Reset for SFP I2C mux, SD) are not available in case you remove this connector. I would recommend to de-active this unused MIO on your Vivado PS IP.

br
John

Philipp Bernhardt

Thank you for your fast reply.

Best regards