Hello,
I am trying to configure and build a petalinux project for TE0808-04-9GI21-AS. Going through the documentation at https://shop.trenz-electronic.de/trenzdownloads/Trenz_Electronic/Modules_and_Module_Carriers/5.2x7.6/TE0808/Reference_Design/2019.2/StarterKit/TE0808-StarterKit-vivado_2019.2-build_15-v.41-02_04_2021.pdf (https://shop.trenz-electronic.de/trenzdownloads/Trenz_Electronic/Modules_and_Module_Carriers/5.2x7.6/TE0808/Reference_Design/2019.2/StarterKit/TE0808-StarterKit-vivado_2019.2-build_15-v.41-02_04_2021.pdf) on page 28 there are some variables that need to be changed. Which files do these variables need to be changed in ? I was trying to grep for these variables inside my petalinux project folder. I am using the board files for vivado and petalinux 2019.2.
Specifically these variables show up in multiple files in the petalinux project folder
Quotecomponents/plnx_workspace/sources/u-boot-xlnx/
but not in the project-spec folder :
CONFIG_SYS_I2C_EEPROM_ADDR=0x50
CONFIG_SYS_I2C_EEPROM_BUS=2
CONFIG_SYS_EEPROM_SIZE=256
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=0
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=0
CONFIG_SYS_I2C_EEPROM_ADDR_LEN=1
In which of these files am I supposed to make the changes ?
Hello.
configuration files produced by petalinux. The better way to make these changes is to run the corresponding petalinux command and make changes in the interface. For example
run "petalinux-config -c u-boot" command, which open the u-boot configuration interface and use the "/" key to run options search (or find needed options in menu) and then
change variable value.
Best regards
Oleksandr Kiyenko
Hello,
thank you this worked. Is there a way to mark an answer as accepted or a problem as resolved ?
Thanks and Regards,
Acevans
Hi,
QuoteIs there a way to mark an answer as accepted or a problem as resolved ?
No, there is no other way to mark it as solved. But thank you for asking.
br
John