Hello,
I'm using the TE0701-05 and the wiki doesn't seem coherent with CPLD configuration.
As describe on this page (https://wiki.trenz-electronic.de/display/4X5B/TE0701+Control+and+Data+Flow+with+TE0720#TE0701ControlandDataFlowwithTE0720-UserPushButtons) the switch S1 should assert the signal RESIN. By measurement the S1 switch has no effect on RESIN, this signal seems only asserted by the S2 switch and also deassert the signal EN1 witch reset the power supplies of the carried board.
How could I only assert the signal RESIN without a reset of the power supplies ?
Best regards,
Julien