Print Page - TE 0304 - VGA-interface SDA and SCL signals

Title: TE 0304 - VGA-interface SDA and SCL signals
Post by: JS on January 08, 2013, 06:34:15 AM

In the docu of the TE 0304, I found, that both signal are announced:

VGA_SCL IO_L22P_3 P3 VGA_SDA IO_L22N_3 P4 for TE0300

VGA_SCL V3_IO_12 T2 VGA_SDA V3_IO_13 T1 for TE0630

... while in the SCH, they seem to be wired to 3,3 over a 2,2k Resistor.

Is this a mismatch?

I did not try so far, but if this is available I would like to try to make use of it.

Title: Re: TE 0304 - VGA-interface SDA and SCL signals
Post by: JS on January 08, 2013, 06:56:52 AM

I think, I got it - it is virtually wired in sheet 2 - so it seems ok.

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: JS on January 08, 2013, 06:34:15 AM