Print Page - Gigabee and Carrier Board power consumption

Title: Gigabee and Carrier Board power consumption
Post by: RDT2 on October 06, 2011, 07:09:53 PM

I'm trying to spec out the amount of batteries I will need to power the Gigabee and it's carrier board. I was hoping you could provide typical current draws for a medium sized/medium speed fpga configuration for your system similar to what is provided on the Digilent devices.

See Page 9 of http://digilentinc.com/Data/Products/ATLYS/Atlys_rm.pdf (http://digilentinc.com/Data/Products/ATLYS/Atlys_rm.pdf)
See Page 8 of http://digilentinc.com/Data/Products/NEXYS3/Nexys3_rm.pdf (http://digilentinc.com/Data/Products/NEXYS3/Nexys3_rm.pdf)

Title: Re: Gigabee and Carrier Board power consumption
Post by: Thorsten Trenz on October 07, 2011, 02:10:08 PM

Hi,
we did a few measurements. Setup was GigaBee on TE0603-02 baseboard, connected to Gigabit Ethernet. 5V Powersupply connected to the baseboard.

FPGA Type \|	Unconfigured \|	Webserver Referencedesign
LX45	0.15A	0.6A
LX100	0.17A	0.5A
LX150	0.2A	0.5A

best regards
Thorsten Trenz

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: RDT2 on October 06, 2011, 07:09:53 PM