Hello Dear Sir/Madam,
I am trying to connect via JTAG to TE0711 Board through the carrier Board i have designed.
I am using:
- Xilinx Vivado 2017.2 version
- Windows 10 OS
- Xilinx Platform cable USB II
When i click Hardware manager-> Open target, the localhost(0) is detected but not the FPGA device.
The Green light on the "Platform Cable USB II" is ON, The Green light on Trenz Board is ON.
Any tips and suggestions to resolve this issue would be very helpful to me..
Best regards
Sathish
Hi,
which carrier did you use? How did you connect JTAG?
br
John
In the Carrier Board PCB which i have designed there is a 9-pin JTAG connector. I have mapped TCK, TDI, TDO and TMS from JM2 connector of Trenz Board. Also 3.3 Volts is connected to the Vref pin. GND pin is grounded as part of the PCB design.
Best regards
Sathish
Hi,
TDI TDO direction is correct?
How did you connect JTAG_SEL Pin (JM1-89)?
See also
- https://wiki.trenz-electronic.de/display/PD/4x5+Module+Integration+Guide
br
John
Hello Dear John,
The 9-pin connections are as follows:
1 - TMS - JM2-93
2 - NC
3 - TDI - JM2-95
4 - TDO - JM2-97
5 - NC
6 - TCK - JM2-99
7 - NC
8 - GND
9 - VCC
JTAG_SEL pin JM1-89 is GND
Best regards
Sathish
Hello,
can you tell me pin connections referred to:
https://www.xilinx.com/support/documentation/data_sheets/ds593.pdf
page 15 Figure 15:
2 -VREF <->JM2-91(3.3V)
8-TDO <- JM2-97
10-TDI -> JM2-95
4-TMS -> JM2-93
6-TCK -> JM2-99
GND <-> GND
Is this correct so?
Did you check power of the boards? Did the module starts?
br
John
Hello Dear John,
I used older Xilinx Vivado version 2014.4 with Windows 7 and it is working now without any issues. The FPGA target is detected and am able to download the .bit file.
Best regards
Sathish