Hello,
I'm trying to get the JTAG server to connect with the programmer on the CYC1000 - and am getting
the following:
Arrow USB Programmer2 Diagnostic Program V1.1
Reading version info.
- Operating system version number is 10.0.17763.
- Quartus version is 18.1.0.625.
Searching programmer hardware.
- Arrow USB Programmer2 AR2E3I3D found.
- Successful.
Reading registry entries for programmer DLL.
- Successful. TCK frequency is 20.000.000 Hz.
Searching programmer DLL.
- Successful. Programmer DLL installed properly.
Checking Altera JTAG server service.
- JTAG Server is installed but not running.
- Error. Wait timed out after sending start request.
Reading registry entries for FTDI driver configuration settings.
- Successful. FTDI driver configuration settings are OK.
Total errors: 1
Hit any key to exit program.
Thanks in advance for any help/hints.
Regards,
John W.
Hello Again,
Guess all is well - I had another USB Blaster plugged in - not sure if that was interfering or what exactly - but seems to be OK now:
F:\Users\John\Downloads>Arrow_USB_Programmer2_diagnostic.exe
Arrow USB Programmer2 Diagnostic Program V1.1
Reading version info.
- Operating system version number is 10.0.17763.
- Quartus version is 18.1.0.625.
Searching programmer hardware.
- Arrow USB Programmer2 AR2E3I3D found.
- Successful.
Reading registry entries for programmer DLL.
- Successful. TCK frequency is 20.000.000 Hz.
Searching programmer DLL.
- Successful. Programmer DLL installed properly.
Checking Altera JTAG server service.
- Service has been stopped successfully.
- Service has been started successfully.
Reading registry entries for FTDI driver configuration settings.
- Successful. FTDI driver configuration settings are OK.
Total errors: 0
Hit any key to exit program.
Regards,
John W.