Hello,
I have TE600-02 and TE603 carrier board and I am experiencing difficulties to download .bit file into the FPGA. I am using Digilent HS1 JTAG-usb cable.
When I open ISE iMPACT and try to download file I get next message :
INFO:iMPACT - Current time: 7.4.2014 11:08:11
PROGRESS_START - Starting Operation.
INFO:iMPACT:583 - '1': The idcode read from the device does not match the idcode in the bsdl File.
INFO:iMPACT:1578 - '1': Device IDCODE : 00001111111111111111111111111111
INFO:iMPACT:1579 - '1': Expected IDCODE: 00000100000000010001000010010011
PROGRESS_END - End Operation.
Elapsed time = 0 sec.
I would appreciate any help or tips.
Thank you.
Tarik.
Hello,
Usually such behaviour caused by bad cable connection.
Do you able to see chip in iMPACT on start ?
Do you have correct power supply for your board ?
Best regards
Oleksandr Kiyenko
Hi Oleksandr,
Yes I can see my chip in iMPACT after Boundary Scan (see attachment). Only after I click to program chip I get message of IDCODE mismatch.
For power supply I am using 9V DC adapter connected to power connector J13.
I bought JTAG cable from Digilent
http://digilentinc.com/Products/Detail.cfm?NavPath=2,395,922&Prod=JTAG-HS1
Thank you.
Regards.
Tarik.