Trenz Electronic GmbH Support Forum
Archived Boards and Threads => Archived Boards => FAQ Eddy Modules => Topic started by: Hengist on May 30, 2011, 05:53:31 PM
Q: what recommendations shall I follow for the hardware development of custom Eddy-CPU base boards?
- connect all ground (GND) pins
- connect all supply voltage (Vcc / 3V3) pins
- connect FPG signal to
- high-level for normal operation
- low level for Flash programming
- pull up the PC16 (nRESET) signal to the supply voltage (Vcc / 3V3) through a 1 kohm resistor