Author Topic: CYC1000 Dimensions  (Read 126 times)

sjoshi

  • Active Member
  • *
  • Posts: 23
CYC1000 Dimensions
« on: September 30, 2021, 04:48:42 PM »
I am looking for the exact dimensions of the CYC1000. More importantly, the exact placement of the PMOD and MKR headers. The dimensions file on the website does not include the PMOD header, hence this post. Could someone please post the exact positions of the headers here?


JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1763
Re: CYC1000 Dimensions
« Reply #1 on: October 01, 2021, 12:39:53 PM »
Hi,
did you checked this document:
https://shop.trenz-electronic.de/en/TEI0003-02-CYC1000-with-Cyclone-10-FPGA-8-MByte-SDRAM?path=Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEI0003/REV02/Documents
--> DIM-TEI0003-02.PDF
it includes dimensions and possition of the pmod(center point). Is this enough for you?

br
John

sjoshi

  • Active Member
  • *
  • Posts: 23
Re: CYC1000 Dimensions
« Reply #2 on: October 01, 2021, 12:58:46 PM »
That will be enough. So the centre line of the mounting holes and the PMOD connecter is the same. Also the PMOD is placed centrally on the board. Is that correct?

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1763
Re: CYC1000 Dimensions
« Reply #3 on: October 01, 2021, 01:27:40 PM »
Hi,
Quote
So the centre line of the mounting holes and the PMOD connecter is the same.
Not directly, its a little bit shifted, so that the connector sleeve is flush with the module.
Quote
Also the PMOD is placed centrally on the board. Is that correct
yes

br
John

sjoshi

  • Active Member
  • *
  • Posts: 23
Re: CYC1000 Dimensions
« Reply #4 on: October 01, 2021, 02:38:34 PM »
Ok. To avoid any confusion, can you please confirm that the point marked by the red arrow in the attached image is the midpoint of the PMOD connecter? Thanks!

Martin R.

  • Active Member
  • *
  • Posts: 4
Re: CYC1000 Dimensions
« Reply #5 on: October 01, 2021, 04:48:47 PM »
Hi,
i checked the project, the center point of the pads of the PMod is 0.291mm shifted inwards compared to the mounting holes, see attached picture
It is also possible to check the Step model, available in HW_Design section.
https://shop.trenz-electronic.de/en/TEI0003-02-CYC1000-with-Cyclone-10-FPGA-8-MByte-SDRAM?path=Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEI0003/REV02/HW_Design
Best regards
Martin

sjoshi

  • Active Member
  • *
  • Posts: 23
Re: CYC1000 Dimensions
« Reply #6 on: October 04, 2021, 12:48:48 PM »
Thanks!