Trenz Electronic GmbH Support Forum

Trenz Electronic Products => UltraScale => Topic started by: ignacio.moreno on November 08, 2017, 11:20:13 AM

Title: TE0820 Default Clock Generator configuration
Post by: ignacio.moreno on November 08, 2017, 11:20:13 AM
Hi everyone,

I have a question regarding the module TE0820-02-03EG-1E3: has the clock generator on the module (SI5338) any default configuration? Unfortunately, I couldn't find this information at the TRM (https://wiki.trenz-electronic.de/display/PD/TE0820+TRM#TE0820TRM-ProgrammableClockGenerator).

I will use the TE0820 for an Embedded System with Linux and USB3.0. To enable USB3, I have to use a GT Lane with 100 MHz on the ZynqMP. For example, GT Lane 1 is clock 2 of the clock generator. I need to know if there is a default configuration because, if not, I have to modify my FSBL in order to program the generator with I2C. Unfortunately I cannot measure it with an oscilloscope because the generator is on the down side of the module.

Thanks in advance!

Regards
Ignacio
Title: Re: TE0820 Default Clock Generator configuration
Post by: JH on November 08, 2017, 02:19:27 PM
Hi,
default disabled. You must configure over I2C. We have a reference design with FSBL programming  example online:
Description:
Download:

br
John
Title: Re: TE0820 Default Clock Generator configuration
Post by: ignacio.moreno on November 08, 2017, 02:50:54 PM
Hi John,

thanks for your quick answer!

Regards,
Ignacio