Print Page - TE0725 3.3v power supply pins.

Title: TE0725 3.3v power supply pins.
Post by: Trenz0691 on January 18, 2023, 05:13:52 PM

Hi
Should be pin 5 & 46 of both J1 and J2 powered with external 3.3v supply in order to power up the module TE0725?
Is it also possible to power up the module by supplying only 3.3v to pin 5 of JB1, JTAG/uart connector?
Thanks

Title: Re: TE0725 3.3v power supply pins.
Post by: Waldi3141 on January 19, 2023, 03:40:14 PM

Hi,
supplying 3,3V to one of those Pins is normally enough to power up the board.
Yes 3.3V can also be supplied over JB1 (mind the power rating of the supply, TE0790 is not suitable here for delivering power)

good luck!

Title: Re: TE0725 3.3v power supply pins.
Post by: Trenz0691 on January 22, 2023, 04:58:22 AM

Thanks @Waldi3141

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: Trenz0691 on January 18, 2023, 05:13:52 PM