Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: FinEnthu on November 21, 2020, 07:25:31 AM

Title: How to program flash on TE0720 with FPGA configuration via JTAG and Vivado2014.2
Post by: FinEnthu on November 21, 2020, 07:25:31 AM
Hi everyone,

I am using TE0720 and have a .bit file currently. I would like to program the flash on TE0720 using JTAG lines. I am currently using Vivado 2014.2
We are not using PS part but have only PL part in our project. I am relatively new on handling this issue.

I went through the wiki page. Under the TE0720 test board tab, I could not find anything about programming the board using JTAG.

Can someone suggest how I can program the flash on TE0720 with FPGA configuration using JTAG lines?

Thanks in advance,


-FinEnthu
Title: Re: How to program flash on TE0720 with FPGA configuration via JTAG and Vivado2014.2
Post by: JH on November 23, 2020, 07:27:37 AM
Hi,
you work with Zynq. QSPI is connected on PS, so you need processor part for booting (minimum FSBL).

We offer reference design for newer Vivado versions:
https://wiki.trenz-electronic.de/display/PD/TE0720+Reference+Designs

Here are  also some references to Xilinx documentation about this topic:
https://wiki.trenz-electronic.de/display/PD/Xilinx+Development+Tools#XilinxDevelopmentTools-XilinxSoftwareProgrammingandDebugging

PS: Is there s reason why you use this very old vivado version from the beginning of Vivado? I would recommend to use newer one.  We use currently 19.2 and we will make next updates to 20.2