Hello everyone,
I have an issue regarding the PHY Led signals of the TE0820 Module:
According to the pinout excel table, PHY_LED0 goes to pin C8 of the Zynq and PHY_LED1 goes to CPLD pin 17. Is this pin 17 connected to some pin of the Zynq? Is this signal used? I would like to have it on the PL to send it to an actual led...
Thanks in advance,
I. Moreno
Hello,
yes, you can use it. See:
- https://wiki.trenz-electronic.de/display/PD/TE0820+CPLD
It's connected on our 2017.2 example design, see description:
- https://wiki.trenz-electronic.de/display/PD/TE0820+Test+Board#TE0820TestBoard-VivadoHWManager
br
John
Hi John,
thanks for the quick response!
Regards
Ignacio