Print Page - Route the voltage pin to FMC connector on TE0701

Title: Route the voltage pin to FMC connector on TE0701
Post by: shengy on April 15, 2018, 01:27:34 AM

Hi

I purchased a TE0701 for its FMC connector but I found the voltage of the pinout didn't match the FMC card I purchased.

Is there any way to fix it through modifying the firmware or FPGA code?

Best,

Title: Re: Route the voltage pin to FMC connector on TE0701
Post by: JH on April 16, 2018, 10:18:35 AM

Hi,
which voltage did you mean?
VADJ is variable on TE0701 -> attention on some FPGA modules, where FPGA Bank voltage allows max 1.8V.
See also:

https://wiki.trenz-electronic.de/display/PD/4+x+5+SoM+Integration+Guide (https://wiki.trenz-electronic.de/display/PD/4+x+5+SoM+Integration+Guide)
https://wiki.trenz-electronic.de/display/PD/TE0701+TRM#TE0701TRM-TE0701jumperandDIPswitchoverview

br
John

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: shengy on April 15, 2018, 01:27:34 AM