Hello,
I would like to connect the PHY LEDs with my platform's LEDs. I can see that PHY_LED0 goes to pin K8 of the FPGA so I can connect it to the PL. But PHY_LED1 goes to the CPLD. If I understand correctly, the CPLD REV02 firmware used to route PHY_LED1 to X1 which is connected to J1. However it's not the case in the CPLD REV03/04 firmware: PHY_LED1 is not used anymore.
Is it possible to use the CPLD REV02 firmware with TE0820-03?
If yes, can you give me a link to that firmware as I couldn't find it on your download page.
Thanks in advance.
Regards,
Emilie
Hi,
write to support@trenz-electronic.de and I will send you source files to change it like you wan't.
br
John