Print Page - TE0703-05 USB

Title: TE0703-05 USB
Post by: sonic on July 04, 2018, 06:34:39 PM

Hello,

I am using TE0703-05 Board's Ethernet to transmit data to Raspberry Pi. I wonder how can I make USB Connector J6 give power over USB?

Is there a jumper that I need to change?

Best Regards

Title: Re: TE0703-05 USB
Post by: Oleksandr Kiyenko on July 06, 2018, 11:14:44 AM

Hello,

USB power is controlled by USB PHY. You need to use a driver which will control USB PHY and enable power.

Best regards
Oleksandr Kiyenko

Trenz Electronic GmbH Support Forum

Trenz Electronic Products => Trenz Electronic FPGA Modules => Topic started by: sonic on July 04, 2018, 06:34:39 PM