Hi
I purchased a TE0701 for its FMC connector but I found the voltage of the pinout didn't match the FMC card I purchased.
Is there any way to fix it through modifying the firmware or FPGA code?
Best,
Hi,
which voltage did you mean?
VADJ is variable on TE0701 -> attention on some FPGA modules, where FPGA Bank voltage allows max 1.8V.
See also:
- https://wiki.trenz-electronic.de/display/PD/4+x+5+SoM+Integration+Guide (https://wiki.trenz-electronic.de/display/PD/4+x+5+SoM+Integration+Guide)
- https://wiki.trenz-electronic.de/display/PD/TE0701+TRM#TE0701TRM-TE0701jumperandDIPswitchoverview
br
John