Hello everyone,
from the Block Diagram of TE0720 to be able to connect the PL to Ethernet PHY I need to use SGMII which is connect to JM3 and than connect to JM3 from bank 34.
my Problem is the schematic ,I dont know to which pin in FPGA should i assigned the ports .
I coonect the microblaze to 1G/2.5G Ethernet with SGMII
LG
Hello,
which Carrier did you use? Which external ETH PHY?
br
John
hi,
I am using TE0706 Carrier with Marvell 88E1512
Hi,
we have an older demo design for TE0706, you can use locs from this design:
- https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Modules_and_Module_Carriers/4x5/TE0720/Reference_Design/2016.2/carrier_te0706_eth
br
John
Hi,
the demo design for TE0706 ist mit RMII ,i want to use SGMII .
can you please give me the FPGA pin i didn't finf any documentation realated to the SGMII FPGA pin
br
Hi,
TE0706 Schematics:
https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Modules_and_Module_Carriers/4x5/4x5_Carriers/TE0706/REV02/Documents
TE0720 schematics:
https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Modules_and_Module_Carriers/4x5/TE0720/REV03/Documents
general pinout planner:
https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Pinout
there is no special document for SGMII interface from us, you must check datasheets. for physical connection of the phy you can use the pinout planner and the schematics
br
John