Trenz Electronic GmbH Support Forum

Community => CYC1000 community projects => Topic started by: sjoshi on September 30, 2021, 04:48:42 PM

Title: CYC1000 Dimensions
Post by: sjoshi on September 30, 2021, 04:48:42 PM
I am looking for the exact dimensions of the CYC1000. More importantly, the exact placement of the PMOD and MKR headers. The dimensions file on the website does not include the PMOD header, hence this post. Could someone please post the exact positions of the headers here?

Title: Re: CYC1000 Dimensions
Post by: JH on October 01, 2021, 12:39:53 PM
Hi,
did you checked this document:
https://shop.trenz-electronic.de/en/TEI0003-02-CYC1000-with-Cyclone-10-FPGA-8-MByte-SDRAM?path=Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEI0003/REV02/Documents
--> DIM-TEI0003-02.PDF
it includes dimensions and possition of the pmod(center point). Is this enough for you?

br
John
Title: Re: CYC1000 Dimensions
Post by: sjoshi on October 01, 2021, 12:58:46 PM
That will be enough. So the centre line of the mounting holes and the PMOD connecter is the same. Also the PMOD is placed centrally on the board. Is that correct?
Title: Re: CYC1000 Dimensions
Post by: JH on October 01, 2021, 01:27:40 PM
Hi,
QuoteSo the centre line of the mounting holes and the PMOD connecter is the same.
Not directly, its a little bit shifted, so that the connector sleeve is flush with the module.
QuoteAlso the PMOD is placed centrally on the board. Is that correct
yes

br
John
Title: Re: CYC1000 Dimensions
Post by: sjoshi on October 01, 2021, 02:38:34 PM
Ok. To avoid any confusion, can you please confirm that the point marked by the red arrow in the attached image is the midpoint of the PMOD connecter? Thanks!
Title: Re: CYC1000 Dimensions
Post by: Martin R. on October 01, 2021, 04:48:47 PM
Hi,
i checked the project, the center point of the pads of the PMod is 0.291mm shifted inwards compared to the mounting holes, see attached picture
It is also possible to check the Step model, available in HW_Design section.
https://shop.trenz-electronic.de/en/TEI0003-02-CYC1000-with-Cyclone-10-FPGA-8-MByte-SDRAM?path=Trenz_Electronic/Modules_and_Module_Carriers/2.5x6.15/TEI0003/REV02/HW_Design
Best regards
Martin
Title: Re: CYC1000 Dimensions
Post by: sjoshi on October 04, 2021, 12:48:48 PM
Thanks!