Author Topic: TE0803 Heatsink  (Read 7211 times)

toshas

  • Active Member
  • *
  • Posts: 11
TE0803 Heatsink
« on: November 11, 2017, 10:58:00 AM »
Hi!

I can't find any cooling solution for TE0803.
Is it compatible with
https://shop.trenz-electronic.de/en/KK0808-03-Cooling-solution-for-Trenz-Electronic-TE0808
or
https://shop.trenz-electronic.de/en/28606-Heatsink-for-Trenz-Electronic-Module-TE0820
Last one even has same C784 package type.

Thanks!

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1987
Re: TE0803 Heatsink
« Reply #1 on: November 14, 2017, 09:27:32 AM »
Hi,

at the moment we have no special heatsink for TE0803 and TE0820.
We will check, if it's possible to use KK0808 on TE0803. I will inform you, if I get results.
But you can't use KK0808 for TE0820.

It's possible to use BGA Heatsink. You found more information to package size and thermal specification on:

br
John

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1987
Re: TE0803 Heatsink
« Reply #2 on: November 14, 2017, 01:33:53 PM »
Hi,

KK0808 is not compatible with TE0803. We will create a heatsink for 803 like KK0808, but i can't tell you a timeline for this task.

br
John

toshas

  • Active Member
  • *
  • Posts: 11
Re: TE0803 Heatsink
« Reply #3 on: November 14, 2017, 02:05:55 PM »
Thanks!

lardilap

  • Active Member
  • *
  • Posts: 1
Re: TE0803 Heatsink
« Reply #4 on: September 27, 2018, 09:28:02 AM »
Hi,

I would like to ask if there is any update on the heatsink for the TE0803.
I have noticed after some minutes of operation it can reach 60+ degrees, so I'm afraid to let it run continuously.
What should be a normal continuous operation temperature without the hearsink? I have a fairly small project inside.

Cheers,
Luis

JH

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1987
Re: TE0803 Heatsink
« Reply #5 on: September 27, 2018, 12:27:31 PM »
Hi,
at the moment we offer:

it's a modified version, so you must order from our shop or modify by yourself.
But it's also possible to use another BGA heatsink with the correct size.

PS: 60°C is OK for FPGA module.
Limit depends on the assembly version:
--> page 5 table 2 --> Xilinx specified junction not environment!

br
John