Open Source > Open source hardware

Zynqberry PS/PL Access to connector J8

(1/1)

sebo:
Hello,

I'd like to know which pins from the connector J8 I can drive from the PL part of the Zynq.
It's not clear to me whether each GPIO can be controlled through PS or PL or both.

Many thanks.

S/

JH:
Hello,

J8 are the most PL IOs, only 2 are direct PS-MIOs. At the moment you can use our master pinout excel sheet or the schematics to get pin number:

* https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Pinout
* https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/TE0726Master Excel Pinout Table need MS-Excel and activated macros, if this is problem for you, write a request to our support and i will send you the generated files.
P.S.:
You can set PS GPIO to EMIO and connect to this to the P8-IOs in the PL part on the block design.
We will generate a complete TRM at the moment, which will be available in the near future on our Wiki:

* https://wiki.trenz-electronic.de/pages/viewpage.action?pageId=24151598
br
John
 

Navigation

[0] Message Index

Go to full version