Attention: For security reasons,please choose a user name *different* from your login name.
Also make sure to choose a secure password and change it regularly.

Main Menu

Zynqberry PS/PL Access to connector J8

Started by sebo, May 10, 2017, 05:19:44 PM

Previous topic - Next topic



I'd like to know which pins from the connector J8 I can drive from the PL part of the Zynq.
It's not clear to me whether each GPIO can be controlled through PS or PL or both.

Many thanks.




J8 are the most PL IOs, only 2 are direct PS-MIOs. At the moment you can use our master pinout excel sheet or the schematics to get pin number:
Master Excel Pinout Table need MS-Excel and activated macros, if this is problem for you, write a request to our support and i will send you the generated files.
You can set PS GPIO to EMIO and connect to this to the P8-IOs in the PL part on the block design.
We will generate a complete TRM at the moment, which will be available in the near future on our Wiki: