Zynqberry PS/PL Access to connector J8

[sebo]

Hello,

I'd like to know which pins from the connector J8 I can drive from the PL part of the Zynq.
It's not clear to me whether each GPIO can be controlled through PS or PL or both.

Many thanks.

S/

[JH]

Hello,

J8 are the most PL IOs, only 2 are direct PS-MIOs. At the moment you can use our master pinout excel sheet or the schematics to get pin number:

• https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/Pinout
• https://shop.trenz-electronic.de/en/Download/?path=Trenz_Electronic/TE0726

Master Excel Pinout Table need MS-Excel and activated macros, if this is problem for you, write a request to our support and i will send you the generated files.
P.S.:
You can set PS GPIO to EMIO and connect to this to the P8-IOs in the PL part on the block design.
We will generate a complete TRM at the moment, which will be available in the near future on our Wiki:

• https://wiki.trenz-electronic.de/pages/viewpage.action?pageId=24151598

br
John