TE0710 B16 Voltage

[Caleb Phillips]

Hello, I am implementing an SD card on a custom carrier board but am a bit uncertain about what voltage B16 operates at. Per the TE0710 schematic, it should be 3.3V which agrees with the TRM; however, there is a note at the top of schematic sheet #13 that states "B16 6 pins, 3 differential; 1.8V fixed VCCIO" which is leaving me a little confused. Just want to make sure that I'm not going to break anything if I bypass the level converter that is used in 0703 and 0706 and wire the SD socket direct to the module.

Thanks!

[JH]

Hello,

this means this 3 pairs go to SD Card on our carrier te0701 with level shifter which sourced by 1.8V from connector side.
See page 8 and 18:
https://www.trenz-electronic.de/fileadmin/docs/Trenz_Electronic/carrier_boards/TE0701/REV06/Documents/SCH-TE0701-06.PDF

Or other 4x5 module carrier. We used SD-Card only on Zynq Modules with 1.8V VCCO on MIO Pin.

Do you want to implement SD on Artix?

br
John