TE0715 + TE0701 Board Program Flash Error

[Jason_Baxter]

Hello,

I have issues writing the flash to the TE0715 mounted on a TE0701 board. I have created an FSBL, imported the prebuilt 04_30_3e_1gb, built the project, created a boot image and then connected the JTAG via mini-USB. I am trying to flash using qspi-x4-single but get the following error. The progress bar hangs and nothing happens. The dip switch (S3-3) is set to the Xilinx chip (on TE0701) and not the CPLD. The board is powered via the 12V supply. I'm unsure what else to do and am looking for guidance. Please let me know if there is any more key information I can provide.

Thank you.

Code Select Expand

****** Xilinx Program Flash
****** Program Flash v2022.2 (64-bit)
  **** SW Build (by xbuild) on 2022-10-13-12:09:39
    ** Copyright 1986-2022 Xilinx, Inc. All Rights Reserved.


WARNING: Failed to connect to hw_server at TCP:127.0.0.1:3121
Attempting to launch hw_server at TCP:127.0.0.1:3121

Connected to hw_server @ TCP:127.0.0.1:3121

Target not specified. Selecting target_id 2 (arm_dap) by default.

Retrieving Flash info...

Initialization done
Using default mini u-boot image file - C:/Xilinx2022/Vitis/2022.2/data\xicom\cfgmem\uboot\zynq_qspi_x4_single.bin
===== mrd->addr=0xF800025C, data=0x00000001 =====
BOOT_MODE REG = 0x00000001
WARNING: [Xicom 50-100] The current boot mode is QSPI.
Flash programming is not supported with the selected boot mode.If flash programming fails, configure device for JTAG boot mode and try again.