TE0701 LVDS connection Problem p -> n n->p

[geimel]

Hello,
I'll use the Camera Link Connector of the TE0701 Carrier Board.
There some connections and  Signal Names where Trenz an Xilinx are not get together.
In the attachement is a part of the TE0701 schematic shown.
For example, the CL_CC4_N signal is connected to J18_B34_T1_L7P.
Why is the N Signal connected to the P pin?
As result, all signals are inverted.

[Antti Lukats]

correct, you need very carefully check the assignment, for CL camera or grabebr configuration and perform inversion where needed.