Bringing up Petalinux on TE0720

[indar]

Hello,

I have a silly problem when trying to run Petalinux on TE0720. Everything works fine except for the ethernet. When I boot-up the system (from SD), is says: "PHY is not detected" before u-boot starts loading the kernel. Although "eht0" is present (and I can change its ip) but I cannot ping my host computer. Does anyone has this kind of problem?
For bringing up the Petalinux, I use the Base Vivado Reference Project (https://github.com/Trenz-Electronic/TE0720-GigaZee-Reference-Designs/tree/master/TE0720-01_Base_Vivado-2013.4) and then follow Petalinux step described in http://www.xilinx.com/support/documentation/sw_manuals/petalinux2013_10/ug980-petalinux-board-bringup.pdf
Fyi, if I run the preloaded (factory default) linux on SPI flash, everything works normally (I don't have any problem with ethernet). I have tried modify the dts file used by Petalinux in accordance to the TE0720-01-2IF.dts (especially in the ethernet section), but the problem still remains.

Any clue or suggestion?
Thanks in advance!

Indar

[Oleksandr Kiyenko]

Hello Indar,

Probably you have some mistake in your configuration. If you send me files you using to boot system, I'll try to help you.
Please send it to a.kienko(at)trenz-electronic.de

Best regards
Oleksandr Kiyenko

[indar]

Hello Oleksandr,

I've sent the configuration files to your email. Have you looked at them? Any comments or suggestions?
Thanks!

best regards,
Indar

[Oleksandr Kiyenko]

Hello Indar,

Your configuration looks almost the same as my old configuration for 3.9, 3.10 kernels. I attach my DTS for 3.13 kernel, please try it on your system.

Best regards
Oleksandr