Archived Boards and Threads > Eddy Modules

Eddy 2.5 problem with debug console

(1/1)

kaml:
Hello

How to enable console input in Eddy 2.5 board?
Uncommenting

--- Code: ---ttyS0::respawn:/sbin/getty -L ttyS0 115200 vt100

--- End code ---
in /etc/inittab only shows "Welcome to the Eddy development environment." in console, but i cannot login.
DBGU uart works  great in u-boot but on linux doesn't.

Regards
kaml

Horsa:
Hello kaml,
you did not describe completely your system set-up.

We assume you are using an Eddy-CPU v2.5 plugged on a Eddy-DK v2.1 development board.
There are no command to enable the console port of Eddy-DK 2.1 with Eddy-CPU v2.5.
Simply plug the DE-09 connector to the console port, then use it.
By the way, users cannot log in from the debugging port.
Use telnet to connect to Eddy and login.

Cheers,
 Horsa

kaml:
Hello

Thanks for reply.
I use  Eddy-DK v2.1 development board.
I just want to use debug serial(UART) console.
I found that in kernel the RX interrupt from debug serial port was disabled. After enabled it everything works.

Regards
kaml

Navigation

[0] Message Index