TE720/TE0701 - MIO bank0 use

[GlennW]

Can you confirm how the TE0720/TE0701 system uses MIO bank0 pins.
From documentation it seems the default configuration is 2xUART and 1xI2C0 and 2xGPIO. Correct?
UART0 is used as the debug serial port, are any of the other interfaces actually used by the default system?

I would like to reassign some of these pins, will this prevent the system from operating (e.g. does the system/module controller depend on any of them)?

Thanks 

[Oleksandr Kiyenko]

Hello,

System controller not depends on this pins.
Minimal configuration is UART0 as debug console.

Best regards
Alex